VuQube V20 Installation And Operating Instructions Manual page 9

INTERNAL WIRING
13. Inside the vehicle, make the connections as shown in (Fig. 5), keeping in mind the following
important points:
a) The connection between the antenna unit and the receiver must be a direct
connection with no devices in between.
b) Power connection must be a non-shared circuit. Excessive current draw on the
circuit will cause the unit to operate improperly. Power and ground connections must be
made after the main harness is plugged into the antenna unit.
c) If fusing the circuit, the fuse must be rated at 7.5 amps.
Fig. 5
Note: HDTV receivers require HDMI or component
video/audio cable connection to TV.
Page 7