VuQube V20 Installation And Operating Instructions Manual page 16

ANTENNA CONFIGURATION FOR DISH NETWORK-continued
DISH HD Western Arc with Locals (satellites 110, 119, 129)
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 20 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure your
receiver for mobile use. To configure your receiver,
GO TO PAGE 18 AND RUN THE CHECK SWITCH.
DISH HD Eastern Arc with Locals (satellites 61.5, 72, 77)
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 12 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure your
receiver for mobile use. To configure your receiver,
GO TO PAGE 18 AND RUN THE CHECK SWITCH.
Page 14
button for 4 seconds.
button for 4 seconds.