Siemens SPCK 420 User Manual page 25

6.2.10.1
6.2.10.2
Siemens AB
Security Products
SMS CONTROL
There is a maximum of four users for SMS configuration on 1 panel and only 1
phone number for each user for use with SMS control functionality.
It is important prerequisites such as an SMS-enabled modem and correct user
profile are met for SMS control.
Depending on the SMS AUTHENTICATION MODE (OPTIONS menu) chosen by
the installation engineer, the user's mode of SMS may vary.
If the system SMS authentication is set to the SMS PIN Code, Caller ID or PIN &
Caller ID, it is necessary to set up SMS control:
1. Scroll to SMS CONTROL and press SELECT.
2. Select the desired configuration option shown in the table below.
3. Press BACK to exit.
CONTROL ENABLE
SMS CALLER ID
SMS PIN CODE
DELETED
COMMANDS ALLOWED
Beyond user type, Engineer settings allow specific rights for functionality to be
granted to each user. If a function explained herein does not appear on user
keypad menus, the user does not have permission for that functionality. Consult
with authorised installation Engineer for appropriate rights and settings.
SMS EVENTS
To receive event notifications, SMS setup must have the phone number; the
number must be enabled for SMS; the events must be toggled for SMS Event
notification.
There is a maximum of four users for SMS configuration on one panel and user
may set a maximum of 5 phone numbers for SMS receipt.
Adding a phone number
To add a phone number for SMS use:
1. Scroll to SMS EVENTS and press SELECT.
2. Scroll to ADD NUMBER and press SELECT.
 The LCD displays SMS NUMBER.
User programming via the keypad
Enable or disable SMS Control.
Provide phone number (requires 3-digit country code prefix)
Provide pin number
Remove phone number as required.
Select the functions that can be performed via SMS. See SMS
Commands [➙ 26] for a list of SMS commands to perform these
functions.
6
User Menus
25
A6V10209178
26.09.2011