Commissioning; Ignition Check; Grill Ignition; Pressure Test Point - New World Built-in Gas Oven Users Manual & Installation Handbook

Commissioning

Pressure test point

Use the oven burner. From inside the
oven remove the burner cowl. Remove
the small screw at the LHS of the burner
cradle. Slide the burner to the left to ac-
cess the injector.
Connect suitable T-piece (incorporating
a 115 injector) to the injector. Connect
manometer to the T-piece, and turn oven
control to full on to check pressure.
Replace in reverse order.
Burner aeration
All burners have fixed aeration and no
adjustment is possible.
Pressure setting
See technical data.
Electrical systems check
In the event of an electrical fault the
preliminary electrical system check (earth
continuity, short circuit, polarity and resis-
tance to earth) must be carried out.
INSTALLATION

Ignition check

Oven ignition:
Push in and turn the main oven control
knob anti clockwise to the 'FULL ON'
position. The ignition system will spark
automatically. Push in the control knob to
ignite the gas. The sparking will stop. If
after 15 seconds, the burner has not lit,
turn off the oven and leave the compart-
ment door open. Wait at least one minute
before a further attempt to ignite the
burner.
Do not hold the control knob in for more
than 15 seconds.
Turn the control knob clockwise to the
required setting.
To turn off, return the control knob to the
"off" position.

Grill ignition:

1. The door must be open for grilling.
2. Push in and turn the control knob
clockwise to the grill symbol.
Before leaving the installation
Show the customer how to ignite the
oven and operate the grill and give them
this handbook. Thank you.