Spraying Soap; Rinsing; Cleaning Soap Siphon Hose - Westinghouse WP2300 Owner's Manual

OPERATION

SPRAYING SOAP

NOTICE
Only use pressure washer–safe soap.
1. Install the soap nozzle (black).
NOTICE
Only use the soap nozzle to apply soap. Using other
nozzles will not apply soap.
2. Prepare soap solution following manufacturer's
instructions.
3. Place soap siphon hose into
NOTICE
Do not route soap siphon hose where it can contact
the muffl er while the engine is running.
4. Make sure the garden hose and high-pressure hose
are connected.
NOTICE
All hoses must be connected before starting the
engine.
5. Turn on the water supply.
6. Start the engine and squeeze the trigger.
7. Use long, even overlapping stroke to apply soap.
8. Allow 3 – 5 minutes for the
washing and rinsing. Do not allow the
dry on the surface before rinsing. Reapply
necessary to maintain a wet surface for the
soak in.
NOTICE
Clean the soap siphon hose once done. See
Cleaning Soap Siphon Hose on page 24.
24
soap container.
soap to soak in before
soap to
soap if
soap to

RINSING

WARNING
Always apply the trigger lock to change
a nozzle if the engine is running.
1. Select the desired nozzle and change nozzle. See
Selecting Nozzles on page 22.
2. Squeeze the trigger and carefully start to spray,
keeping nozzle a safe distance from the cleaning
surface.
3. Starting from the top of the surface, spray a small
area then check surface for damage. If no damage,
continue rinsing by using overlapping strokes
working down the surface. Keep checking surface
for damage while rinsing.
CLEANING SOAP SIPHON
HOSE
If used, clean the soap siphon hose before stopping the
engine.
1. If necessary, install the
2. Use clean water to fl ush the
Submerge the soap siphon hose in the clean water.
3. Flush the soap siphon hose for 1 – 2 minutes while
the engine is running.
4. Once clean, stop the engine.
5. Point spray gun in a safe direction. Squeeze the
trigger to release pressure within the system.
soap nozzle (black).
soap siphon hose.