Selecting Nozzles; Changing The Nozzle; Spraying Tips - Westinghouse WPX3400 User Manual

Gas pressure washer
Hide thumbs Also See for WPX3400:
Table of Contents

Advertisement

6. Disconnect the garden hose from the water inlet.
7. Complete all steps in the AFTER EACH USE section of
this manual.
DURING AN EMERGENCY
If there is an emergency and the pressure washer must
be stopped quickly, push the engine control switch to OFF
position immediately.

SELECTING NOZZLES

The quick-connect coupler on the spray lance allows
changing between nozzles while the pressure washer is
running.
Always engage the trigger lock before changing a nozzle.
Only use the nozzles that were supplied with the
pressure washers. Using any other nozzles can affect
performance and may void the warranty. For replacement
nozzles call (855) 944-3571.
Concrete, Brick, Masonry
Siding, Gutters, Home
Fencing, Deck, Patio
Lawn and Garden Equipment,
Boats, RVs
Recommened nozzle
NOTICE
Use with caution

CHANGING THE NOZZLE

Pull back the quick-connect collar at the end of the spray
lance. Insert the nozzle then release the collar. Pull on the
nozzle to make sure it is secured.

SPRAYING TIPS

For most cleaning, keep nozzle 8 - 24 in. (20 - 61 cm) away
from cleaning surface.
• Damage may occur to the cleaning surface if you spray
too close, especially with high-pressure nozzles.
• When beginning to spray, start farther away and move
closer to avoid damage to the surface.
• To prevent damage to tires, allow at least 6 in. (15 cm)
between a tire and the nozzle.
NOZZLE SELECTION
HIGH PRESSURE WASH
RED
YELLOW GREEN
o
o
0
15
X
X
X
Do not use
X
Westinghouse Outdoor Power Equipment, LLC | 13
OPERATION
LOW PRESSURE
WHITE
o
o
25
40
WASH
SOAP

Advertisement

Table of Contents
loading

Table of Contents