Connecting The Interface Cable - Star Micronics XB24-200 User Manual

-
Print head
Print head
Ribbon canridee \- /
shield
Figufe Z-4. Installing the ribbon cartridge.
After you have installed the ribbon cartridge, close the front cover.
Leave the front cover closed during normal operation. The cover keeps out
dust and dirt and reduces the printer's operating sounds. Open the cover only
to change the ribbon or make an adjustment.
Connecting the interface cab/e
Connect the printer to your computer using a standard Centronics parallel
interface cable. On a PS/2 or PC/AT-type computer, this means that you use
the 25pin D-type connector at the computerend, and the Amphenol-type 36-
pin connector at the printer end. The configuration of the printer's connector
is given in Chapter 11 should you need a cable for connecting to another
computer.
If you need to connect to a serial port, use the optional Serial RS-232 interface
cartridge, IS-8XL.
Follow the procedures below to connect the interface cable:
1. Turn off the power switch both the printer and the computer.
2. Connect the interface cable to the printer as shown in Figure 2-5.
Make sure that you press the plug fully into the interface connector.
12
-
-
-
-
-
-
-
'v
-