HP P4000 SAN User Manual page 18

Best practices for deploying citrix xenserver

Hide thumbs Also See for P4000 SAN:

Table of Contents

Figure 8. Bonding network adapters NIC 4 and NIC 5

Figure 8 shows the creation of a network bond consisting of NIC 4 and NIC 5 to connect the host

to the iSCSI SAN and, thus, the SRs that are common to all hosts. NIC 2 and NIC 3 had already

been bonded to form a single logical network link for Ethernet traffic.

The network in this example consists of a class C subnet of 255.255.255.0 with a network address

of 1.1.1.0. No gateway is configured. IP addressing is set using the pif-reconfigure-ip command.

As shown in Figure 9, select Properties for each bonded network; rename Bond 2+3 to Bond 0

and rename Bond 4+5 to Bond 1; and enter appropriate descriptions for these networks.

Table of Contents

Storageworks p4000 san