Table of Contents
Advertisement
A Place firebox on cart. Attach with #10-24x2" machine screws, fiber washers and #10-24 wing nuts.
9
B Place burner assembly into firebox. Make sure venturi tubes and valves are correctly engaged. If burner is not
leveled from left to right, adjust the two screws attaching valve to control panel in Step 9. Attach burner
assembly to firebox with fiber washers and #8 sheet metal screws.
C Insert #10-24x1-1/4" screws into each side of firebox as shown, and attach fiber washers and flanged nuts
to screws as shown.
D Push control knobs onto valve stems.
E Connect ignitor wire to electrode terminal on burner.
Qty: 2
#8 Sheet Metal Screw
Attach heat shield to left upper bracket using #10-24x1/2" machine screws and #10-24 wing nuts.
10
Fiber Washer
A
Qty: 14
Fiber Washer
D
Qty. 2
Qty: 2
#10-24
#10-24x1/2"
Wing Nut
Machine Screw
#10-24
Wing Nut
C
Fiber Washer
Fiber Washer
B
#8 Sheet Metal Screw
Qty: 4
#10-24
Flange Nut
Warning: Make sure heat shield is placed above the
two venturis, or else it drops down and may fail to
protect tank from being overheated.
Qty.4
Qty: 4
#10-24x1-1/4"
Machine Screw
Correctly assembled
valve in
E
Heat
Shield
Qty: 4
#10-24x2"
Machine Screw
burner tube
Ignitor Wire
461632208 • 17
Advertisement
Table of Contents
