Clear Button; Expansion Module Leds - HP ProCurve Series Installation And Getting Started Manual

Clear Button

This button is used for these purposes:
Deleting Passwords - When pressed by itself for at least one second, the
■
button deletes any switch console access passwords that you may have
configured. Use this feature if you have misplaced the password and need
console access.
This button is provided for your convenience, but its presence means that
if you are concerned with the security of the switch configuration and
operation, you should make sure the switch is installed in a secure
location, such as a locked wiring closet.
Restoring Factory Default Configuration - When pressed with the
■
Reset button in a specific pattern, any configuration changes you may
have made through the switch console, the web browser interface, and
SNMP management are removed, and the factory default configuration is
restored to the switch. For the specific method to restore the factory
default configuration, see
on page 11, in chapter 4, "Troubleshooting" of this manual.

Expansion Module LEDs

"Expansion Module" LEDs refer to the LEDs specific to the expansion module.
These LEDs are located on the physical expansion module bulkhead. These
LEDs are only viewable in the rear of the Switch 3500yl-48G product on the
Expansion Slot Module itself. These LEDs are duplicated on the front panel
of the Switch 3500yl-24G and 6200yl-24G devices.
"Restoring the Factory Default Configuration"
Introducing the Switch
Front of the Switch
1-9