HP J3178A Hardware Installation Manual page 101

1.
2.
Using ZGet and ZPut To Transfer a Configuration Between
the Switch and a PC or Unix Workstation
The PC or workstation must be operating as a VT-100 or ANSI terminal, and
can be connected either directly or via a modem to the switch's console port.
Also, the PC or workstation must be running a Zmodem-compatible terminal
emulation program. If a manager password has been set, you must log on to
the switch using that password in order to execute the Zget or Zput commands.
N o t e
ZGet overwrites the switch's current configuration with the downloaded
configuration.
To use ZGet or ZPut, you need the name assigned to the configuration file on
the PC or workstation
1.
2.
From the Main Menu select Advanced Commands
At the command prompt, execute one of the following commands:
To upload a configuration to a file on a PC or Unix workstation:
put IP_address CONFIG remote_file
put IPX_address CONFIG remote_file
To download a configuration from a file on a PC or Unix workstation:
get IP_address CONFIG remote_file
get IPX_address CONFIG remote_file
where: IP_address or IPX_address is the address of the PC or Unix
workstation in which the configuration is to be stored.
remote_file is the name of the configuration file in the PC or
Unix workstation
On the PC or workstation, start the Zmodem-compatible terminal emula-
tion program, then follow the instructions provided with the program to
prepare for a file transfer.
From the switch console's Main Menu select Advanced Commands.
File Transfers
Transferring Switch Configurations
C-9