Snmp Settings; Backup/Restore Settings, Reset To Factory Default Settings - EnGenius Wireless Outdoor Access Point & Client Bridge User Manual

Long Range Wireless Access Point / Client Bridge Version 1.0
Remote Management Port: Specify a port for remote management. For example, if
you specify 8080, then you will need to specify <IP address>:<port>
192.168.1.1:8080 to connect to the web interface of the device.
Click on the Apply button to save the changes.

5.5.8 SNMP Settings

Click on the SNMP Settings link under the Management menu. This option allows
you to assign the contact details, location, and community name and trap settings for
SNMP. This is a networking management protocol used to monitor network-attached
devices. SNMP allows messages (called protocol data units) to be sent to various
parts of a network. Upon receiving these messages, SNMP-compatible devices
(called agents) return data stored in their Management Information Bases. .
SNMP Enable/Disable: Choose to enable or disable the SNMP feature.
Contact: Specify the contact details of the device.
Location: Specify the location of the device.
Read-Only Community Name: Specify the password for access the SNMP
community for read only access.
Read-Write Community Name: Specify the password for access to the SNMP
community with read/write access.
Send SNMP Trap: Specify the IP address of the computer that will receive the
SNMP traps.
Trap Community Name: Specify the password for the SNMP trap community.
Click on the Apply button to save the changes.

5.5.9 Backup/Restore settings, Reset to factory default settings

Click on the Backup/Restore Setting link under the Management menu. This option
is used to save the current settings of the device in a file on your local disk or load
settings on to the device from a local disk. This feature is very handy for
administrators who have several devices that need to be configured with the same
settings.
51
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299