Cleaning And Maintenance; Enamelled Parts - Prestige PR1-DO Instructions For Use Manual

5
GENERAL ADVICE
Important:
Before any operation of cleaning and
maintenance disconnect the appli-
ance from the electrical supply.
It is advisable to clean when the appli-
ance is cold and especially for cleaning
the enamelled parts.
Avoid leaving alkaline or acidic sub-
stances (lemon juice, vinegar, etc.) on
the surfaces.
Avoid using cleaning products with a
chlorine or acidic base.
The oven must always be cleaned after
every use, using suitable products.

ENAMELLED PARTS

All the enamelled parts must be cleaned
with a sponge and soapy water only or
other non-abrasive products.
Dry preferably with a microfibre or soft
cloth.
Do not use harsh abrasive cleaners
or sharp metal scrapers to clean the
oven door glass since they can
scratch the surface, which may
result in shattering of the glass.
Do not use a steam cleaner
because the moisture can get into
the appliance thus make it unsafe.
Do not store flammable material in
the ovens.

CLEANING AND MAINTENANCE

STAINLESS STEEL AND ALUMINIUM
PARTS AND SILK-SCREEN PRINTED
SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratch-
ing and abrasion. You are advised to use
a soft cloth and neutral soap.
WARNING
When correctly installed, your product
meets all safety requirements laid
down for this type of product catego-
ry. However special care should be
taken around the rear or the under-
neath of the appliance as these areas
are not designed or intended to be
touched and may contain sharp or
rough edges, that may cause injury.
INSIDE OF OVEN
The oven should always be cleaned
after use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution
water. Suitable proprietary chemical
cleaners may be used after first consult-
ing with the manufacturers recommen-
dations and testing a small sample of
the oven cavity. Abrasive cleaning
agents or scouring pads/cloths should
not be used on the cavity surface.
NOTE: The manufacturers of this
appliance will accept no responsibility
for damage caused by chemical or
abrasive cleaning.
Let the oven cool down and pay
special attention no to touch the hot
heating elements inside the oven
cavity.
and warm
15