Installing the IP Console Switch
Using Standard 1U Installation
To install the console switch:
1. Attach the slide rail brackets to the console switch, using the two screws on
each side.
2. Use the template that was shipped with the component to mark the location of the
mounting hardware.
a. Push back the tabs (marked
the correct holes in the mounting rails.
Figure 2-9: Measuring with the rack template
b. Match up the hole pattern, indicated on the sides of the template, with the
hole pattern on the mounting rails.
c. Measuring from the top of the component immediately below the new
component, place the template against the front and rear of the rack frame to
mark the attachment points for the mounting rails and rear cage nuts.
2-10
) on the top of the template, and place them in
HP IP Console Switch User Guide