HP 263924-002 User Manual page 112

6. Get the IP address of the TFTP server by extracting it from the operating system
tools (might be operating system-dependent):
a. Right-click Network Neighborhood.
b. Select Properties.
c. Select the Protocols tab.
d. Select TCP/IP protocol.
e. Select Properties.
f. Note the IP address.
7. Assign the IP address in the IP Console Switch, if needed:
a. In the IPViewer HyperTerminal dialog box, enter
Network Configuration.
b. Note the IP Console Switches IP address. The first three numbers must be the
same as in the servers IP address from step 6. The last number must be
different. If the IP Console Switches IP address is not correct, change it as
follows: Enter
and press the Enter key.
c. Enter
address, wait for the directions in the window.
d. Change the IP Console Switch IP address in the TFTP server software to
match, if there was a change.
8. From the IPViewer HyperTerminal dialog box, enter
Management menu. The current version the firmware is displayed in the
Firmware Management menu.
9. From the Firmware Management menu, enter
10. Enter the IP address of the TFTP server.
11. Enter the path and name of the FLASH file, for example HP IP Console
Firmware version X.X.X, and press the Enter key.
NOTE: For Linux operating systems a path name is not required; however, the firmware
images should be saved in the TFTPBoot folder.
HP IP Console Switch User Guide
to select IP address, and then enter the correct IP address,
3
to exit the Network Configuration menu. If the user changed the IP
0
Upgrading Firmware using TFTP
to select
1
to select Firmware
2
to select FLASH Download.
1
7-17