Energy V-6.3 Owner's Manual page 7

MOUNTING YOUR V-MINI AND V-MINI CENTER SPEAKERS
NOTE:The V-Mini includes a very simple wall mounting system.The V-Mini
Center uses the same bracket,but it is NOT included. Careful attention
must be made to mount it securely as the speaker is heavy and damage
to the product and/or injury could result from improper mounting. Please
follow the directions carefully!
Reference Figures 1-7 on opposite side of this page:
1. Select the mounting position best suited for your room.
2. Place the wall mounting bracket against the wall in the desired
mounting location and mark the center of the two holes with a pencil.
This is where you need to insert the appropriate mounting hardware
to securely fasten a load of 15 Ibs. Hardware is not included with the
speaker,as building materials vary greatly in different countries,but
the recommended screw head size is a #8. Screw length is to be
determined by the wall material. /
3. If you are mounting directly to drywall,please
ensur~hat
you use the
appropriate anchors, as screws into drywall itself will not provide a
secure mount. Insert the anchors, and then hold the mounting bracket
up to the wall.lnsert the screws until tight. Try to locate into wall studs
wherever possible.
4. The mounting bracket is very flexible and can be installed in one of
four different positions on the rear of the speaker, depending on your
application. Using the included allen key,remove the screw on the rear
terminal plate that suits your installation and put this screw aside, it
is NOT used with the mounting bracket. Using the 16mm long screw
packaged with the bracket, attach the bracket to the back of the
speaker terminal plate. The top and bottom screws will allow you the
most flexibility in terms of horizontal adjustment, while the left or right
screws will give you the most flexibility in terms of vertical adjustment.
5. Bring the two pieces of the bracket together and screw the included
bolt until snug. Using the included allen key, tighten the screw to hold
the speaker in place once the final position has been chosen. Do not
overtighten.
'~-'
\