Rear Vent Conversion; Special Vent Systems - Empire Comfort Systems DVP36PP32EN-3 Series Installation Instructions And Owner's Manual

Note: It is recommended that the
flue cover plate tab be pulled
outward prior to removal.
This will ensure that the plate
is not accidentally dropped
FLUE OUTLET COLLAR
inside the rear air chamber.
FLUE COVER PLATE
(See note above.)
Converting flue take-off to rear venting
When switching out the flue and inlet vent collars to run horizontally
off the rear vent, the following steps must be taken.
1. Remove the inlet vent collar (8 screws) and flue collar (4 screws)
from the top of the fireplace, and set to the side.
2. Remove the inlet cover plate (4 screws) and flue cover plate
(4 screws) located on the back of the fireplace. These will be
used to close the top flue and inlet openings.
3. Install flue cover plate over the top flue opening with 4 screws.
The following vent systems are acceptable for use with the DVP36(SP,PP) series fireplaces:
• Simpson Duravent® PRO Series 4" - 6 ⅝"
• Selkirk Direct-Temp® 4" - 6 ⅝"
• Metal-Fab Sureseal® 4" - 6 1/2" (Note: Adapter pipe starter required)
• Empire Horizontal Round Termination Kit DVVK-4RE, refer to page 39.
• Empire Flexvent Kit DVVK-4F, refer to page 42.
• Empire Flexvent Kit DVVK-4FV Vertical Flex Vent Kit, refer to page 23.
Page 14

REAR VENT CONVERSION

VERTICAL VENTING
INLET VENT COLLAR
INLET VENT
COVER PLATE
Figure 11

SPECIAL VENT SYSTEMS

FLUE COVER PLATE
FLUE OUTLET COLLAR
4. Reinstall the inlet cover plate over the top inlet opening with 4
screws. See Figure 11.
5. Install the flue collar assembly to the rear flue with 4 screws.
6. Install the inlet vent collar to the rear of the fireplace with 8
screws.
7. This completes the conversion for a rear vent application.
HORIZONTAL VENTING
INLET VENT
COVER PLATE
INLET VENT COLLAR
30786-3-0614