Vermont Castings 1920 Homeowner's Installation And Operating Manual page 10

Aspen Woodburning Stove
®
connecting flue pipe - clearances
Single wall connecting fluepipes can reach extremely
high temperatures; therefore, clearances from the con-
necting fluepipe (chimney connector) must comply with
the requirements of Part J of Building Regulations 000
(Combustion Appliances and Fuel Storage Systems).
This can be achieved by following the recommenda-
tions of Approved Document 'J'. These are as shown in
Figure 11.
at least
3 x D
at least
1.5 x D
elevation
without
Shield
fig. 11 Connecting fluepipe clearances.
10
D
at least 1.5
x D
at least 3 x D
Fluepipe
plan without
Shield
elevation
with Shield
at least
D
1.5 x D
at least
1.5 x D
at least
1.5 x D
Air space of at least 1 mm
between noncombustible shield
and combustible material
plan with
Shield
30003844
ST911