Cub Cadet CC 94M Operator's Manual page 11

Side Discharge Chute
Follow steps below to install the side discharge chute:
1. Remove mulching baffle or grass bag adapter from unit by
disconnecting wing nuts.
2. Attach side discharge chute to unit and secure with the
three wing nuts. See Fig. 3-6.
Figure 3-6
Adjustments
Cutting Height
The cutting height adjustment lever is located above the rear left
wheel. See Fig. 3-7.
2
1
3
Figure 3-7
1. Pull lever out and away from mower.
2. Move lever forward or back for desired cutting height.
3. Release lever towards mower deck.
Drive Control
The adjustment wheel is located in the drive control handle
housing and is used to tighten or loosen the drive belt. You will
have to adjust the drive control if any of the following happens:
1. The mower does not propel itself with the drive control
engaged.
2. The mower's drive wheels hesitate with the drive control
engaged.
If either of these conditions occur, rotate the adjustment wheel
clockwise to tighten and counter-clockwise to loosen cable to
adjust the drive control. See Fig. 3-8.
Figure 3-8
NOTE: For some people the drive control may not be in a
comfortable position. You can adjust the handle by tightening
the adjustment wheel.
Set-Up
Gas and Oil Fill-Up
Refer to the Engine Operation section in this manual for
additional engine information.
1. Add oil provided before starting unit for the first time out
of the box.
2. Service the engine with gasoline as instructed in the
Engine Operation section of this manual.
WARNING:
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
s
ectiOn
Tighten
Loosen
3 — a & s -u
sseMbly et p
11