Recommended Cutting Equipment For Canada - Husqvarna 560XP Operator's Manual

Recommended cutting equipment for Canada

The following is a list of recommended cutting equipment for Chainsaws Husqvarna 555, 560XP, 560XPG, 562XP and
562XPG. The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws
and Z62.1-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
The following cutting attachments are approved for the models Husqvarna 555, 560XP and 560XPG.
Length, inch Pitch, inch
13
15
16 0,325
18
20
15
16
18 3/8
20
24
The following cutting attachments are approved for the models Husqvarna 562XP and 562XPG.
Length, inch Pitch, inch
16
18
20 3/8
24
28
38 – English
TECHNICAL DATA
Bar
Max. nose
Gauge, inch
radius
10T
12T
0,058
11T
Bar
Max. nose
Gauge, inch
radius
0,058 11T
Chain
Drive link
Type
count
56
64
Husqvarna H25 66
72
78
56
60
Husqvarna H42,
68
Husqvarna H48
72
84
Chain
Drive link
Type
count
60
68
Husqvarna H42,
72
Husqvarna H48
84
92