Removal Electrical Capacitor - Biasi Activ A 25C Service Manual

E
D
C
I
F
B
A
Fig. 7.4
6 C.H. only model remove the fork F, loosen the
connection G and remove the pipe H (Fig. 7.4).
7 C.H. only model remove the fork I and remove the
pressure gauge pipe J (Fig. 7.4).
8 Remove the locking plate K (Fig. 7.3 --- Fig. 7.4).
9 Unscrew the two screws L that hold the pump on
the frame and remove the pump.
Reassemble the pump carrying out the removal oper-
ations in the reverse order. When reassembling the
pump, check the correct location of the O---ring gasket
in the inlet port of the pump that seals the connection
between the pump and the plastic group.
7.4

Removal electrical capacitor

Warning: isolate the boiler from the mains
electricity supply before removing any
covering or component.
1 Remove the front and right hand side case pan-
els.
2 Disconnect the connector B (Fig. 7.3) following
the indications given on the connector box.
3 Remove the connector M of the cover box by
levering with a screwdriver in as shown in
(Fig. 7.5)
G
H
J
K
L
Fig. 7.5
Remove the capacitor connection block N freeing
4
it from the hook O and pulling it as indicated by
the arrow (Fig. 7.6).
Fig. 7.6
N O
Pump
M
15