HP AA-RTDRB-TE User Manual page 93

Note:
■
■
■
■
■
■
■
■
■
■
■
Embedded Web Server User Guide
Note that if port optics have also failed, the amber LED will be on.
Invalid Attachment — The switch port is in an invalid attachment
state.
Link Incident — A link incident occurred on one of the ports.
Link Reset — The switch and the attached device are performing a link
reset operation to recover the link connection. Ordinarily, this is a transient
state.
No Light — No signal (light) is being received on the switch port. This is a
normal condition when there is no cable plugged into the port or when the
power of the device attached to the other end of the link is off.
Not installed — The port optics are not installed or the feature that
provides additional port function is not enabled.
Not Operational — The switch port is receiving the Fibre Channel not
operational sequence (NOS) indicating that the attached device is not
operational.
Online — The attached device has successfully connected to the switch and
is ready to communicate or is in the process of communicating with other
attached devices.
Offline — The switch port was configured as "blocked" and is
transmitting the Fibre Channel OLS to the attached device.
Port Failure — The switch port has failed and requires service. (A port
in the failed state cannot beacon.)
Segmented E_Port — The E_Port is segmented preventing the two
fabrics from joining (this only occurs when two switches are connected to
each other).
Testing — Port is executing an internal loopback test.
Monitoring Products
93