Where To Start; Starting Ews - HP AA-RTDRB-TE User Manual

Where to Start

Depending upon whether the Hewlett-Packard product you purchased has already
been installed, you may need to go to a specific chapter. If the product has not
been installed, you should start at
If the product was installed, then many of the configuration tasks were probably
already completed. In that case, you may need to configure a zone. Configuring
(including adding, deleting, and changing) zones is described in
If the products have been configured and you have a functioning SAN, then you
most likely will be interested in performing system administration tasks. Those
tasks are described in
If you need to perform troubleshooting, then you will want to review
and

Starting EWS

Open the EWS interface as follows:
1. Ensure the workstation (or device you use to launch the web browser) and the
Note:
product in order to login to the product.
2. Launch the web browser application (such as Netscape Navigator, version 4.6
3. At the web browser, enter the IP address of the product as the Internet uniform
Note:
service manual for the appropriate IP address, login ID, and password that is initially
used when you install and configure the product.
Embedded Web Server User Guide
Chapter
Chapter 6.
Ethernet LAN segment containing the product, such as Edge Switch 2/24, are
attached and connected through the Internet.
You must be able to make a connection between the web browser and the
or higher, or Microsoft Internet Explorer, version 4.0 or higher).
resource locator (URL) such as http://10.1.1.11.
If the product has not been installed, refer to the product's installation and
Chapter 2.
4, Chapter 5, and Chapter
Introduction
Chapter 3.
6.
Chapter 5
23