Connecting Speakers; Connecting The Antenna; Completing The Connections; Testing The Connections - Radio Shack AM/FM Cassette Car Stereo Owner's Manual

12-2004a.fm Page 7 Friday, January 21, 2000 4:45 PM
If you do not use this wire, secure it
with a wire tie and do not let its bare
wire ends touch metal (if you cut it).

Connecting Speakers

1. Connect the gray wire to the right
speaker's positive terminal. This ter-
minal is usually marked with a plus
(+) sign or red mark.
2. Connect the gray/black wire to the
right speaker's negative terminal.
This terminal might be marked with
–
a minus ( ) sign or it might not be
marked at all.
3. Connect the white wire to the left
speaker's positive terminal.
4. Connect the white/black wire to the
left speaker's negative terminal.

Connecting the Antenna

Connect the vehicle's antenna cable to
the antenna jack on the back of the ste-
reo.
Antenna Cable

Completing the Connections

After you have securely made all other
connections, plug the harness' connec-
tor into the stereo's 14-pin wiring socket.
14-Pin
Wiring Socket
14-Pin
Connector
Then reconnect the cable to the vehi-
cle's negative (–) battery terminal.
TESTING THE
CONNECTIONS
Turn on your vehicle's ignition then turn
clockwise until it clicks. The
OFF/VOL
front of the stereo lights.
If the stereo does not work, immediate-
ly disconnect the cable from your ve-
hicle's negative (–) battery terminal.
Then recheck your connections.
After you verify that the front of the ste-
reo lights, follow the instructions in
"Mounting the Stereo" on Page 8.
7