Buttons - Pfaff ambition essential Owner's Manual

Buttons

8
6
4
3 5
2
1
Reverse (1)
For permanent reverse, press the button before
starting to sew. An icon on the LCD display will
indicate that reverse is activated (see next page).
The icon will be visible and the machine sews in
reverse until you press the button again to cancel.
If you press the reverse button while sewing, the
machine sews in reverse for as long as you keep the
button pressed.
Reverse is also used when sewing the darning stitch.
Needle up/down (2)
Press this button to move the needle up or down.
The setting of the needle stop position is changed
at the same time. An icon on the LCD display
shows the set needle stop position.
You can also tap the foot control to raise or lower
the needle.
Mode selection button (3)
When you turn the machine on it is set to direct
selection mode. Press this button to switch to
pattern mode. A second press will switch to
alphabet mode and a third press will switch back
to direct selection mode.
Auto-lock (4)
For straight stitches (direct selection stitches 0 and
1, and pattern mode stitches 17 and 48) press this
button to sew tie-off stitches immediately and
automatically stop. The Auto-lock icon appears on
the display.
For other stitches, press this button to sew tie-off
stitches at the end of the current stitch pattern and
20
9
7
10
automatically stop. The Auto-stop icon appears on
the display.
Note: The Auto-lock function is not available for pattern
mode stitches 07-16.
Mirror side to side (5)
For mirroring stitches and sequences side to side.
Memory (6)
Press this button to enter sequencing. After
programming a sequence, pressing this button will
save the programmed sequence in the machine
memory.
Delete (7)
For deleting stitches in a sequence.
Arrow buttons (8)
In sequencing, press the left or right arrow button
to step through the sequence. The LCD display
shows the number of the current stitch and the
approximate position in the sequence.
Stitch length (9)
Increase or decrease the stitch length using the "+"
and "-" buttons.
Stitch width or stitch positioning (10)
Increase or decrease the stitch width using the "+"
and "-" buttons.
For straight stitches, use the "+" and "-" buttons to
change the stitch position.
11