Table of Contents
Advertisement
4.
Loosen the two screws in the lamp cover
5.
Remove the two screws
module
.
5
6.
Insert the new lamp module into the projector and tighten the two screws.
7.
Replace the lamp cover and tighten the two screws.
8.
Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling
the lamp.
9.
Press enter, go to Setup > Advanced setup > Reset lamp hours, and press enter.
and remove the cover
1
from the lamp module, raise the handle
3
.
2
, and lift out the
4
Performing routine maintenance
41
Advertisement
Table of Contents
