Message Waiting Indicator (Mwi) - Yealink SIP-T22 User Manual

User Guide SIP-T22P/SIP-T22 IP Phone
To configure voice mail access codes via phone user interface:
1. Press Me nu->Messages->Voice Mail->Set Voice Mail.
2. Press
to select the proper input mode and then enter the voice mail access code.
3. Press the Save soft key to accept the change or the Back soft key to cancel.
Not e
Voice mail access code must be predefined on the system server. Contact your system
administrator for the more information.
To listen t o voice mails:
1. When the phone user interface prompts receiving new voice mails, press
the Connect soft key to dial out the voice mail access code.
2. Follow the voice prompt to listen to voice mails.
Not e
Before listening to the voice mails, make sure the voice mail access code has been
configured.
When all new voice mails are retrieved, the MESSAGE key LED will go out.
To v iew voice mails via phone user interface:
1. Press Me nu->Messages->Voice Mail->View Voice Mail.
The LCD screen displays the amount of new and old voice mails.
2. Select an account and then press the Connect soft key to listen to voice mails.
The SIP-T22P/SIP-T22 IP phone supports MWI when receiving a new voice message. If
someone leaves you a voice mail, you will receive a message waiting indicator. MWI
114
or to select the account which you want to set, press the 1 2 3 soft key
or