Table of Contents

Advertisement

Operati s
Getting ready
1.
To fill the clean water/solution tank.
A.
Remove the tank by lifting it straight
up and then away from the unit.
B.
Unscrew the black cap at the bottom
of the clean water/solution tank and
remove bottle insert.
C.
Measure 4oz. of formula (2 capfulls)
and pour into tank. Fill the clean
water/solution tank with hot (not
boiling) tap water to the WATER
fill line. Replace and tighten black
cap. DO NOT BOIL OR MICROWAVE
WATER.
D.
Replace the clean water/solution tank
by lining up the vertical guides on the
left side of the unit with the indenta-
tions on the clean water/solution tank
and gently slide it down into position.
2.
Release flex hose by twisting the bracket
latch clockwise. Unwrap flex hose
completely from around the unit.
3.
Attach the tough stain brush tool to the
spray trigger by inserting the tool onto
spray trigger firmly until the button lock
snaps into hole. Make certain the tool is
securely attached.
4.
Twist the Quick Release cord wrap
clockwise to unwrap the power cord
completely from onboard cord stor-
age and plug into 120 Volt grounded
outlet, as described in Important Safety
Instructions, page 3.
5.
Press and hold spray trigger—spray will
start in a few seconds. Raise the tool
slightly to check for spray.
Pre-treating
Cleaning effectiveness will be enhanced if you
pre-treat heavily stained or highly-soiled areas.
Here's how to do it:
1.
Hold the cleaning tool just above the
surface of the carpet or upholstery to be
cleaned. Press the trigger to release a
spray of cleaning solution directly onto
the soiled area.
2.
Wait 3-5 minutes before cleaning.
WARNING:
Do not use this product while on any type of ladder. Do not place the product in a
place where it will be stepped on or kicked while in use. Do not place the product on
an elevated surface where it may be pulled off the surface while in use.
WARNING:
Do not use an extension cord with this product.
The use of an extension cord may result in a severe
electrical shock, particularly if the extension cord does
not have an electrical rating higher than that of the
product, OR if the extension cord does not have a
three-prong grounding plug and if the extension cord
is not plugged into a circuit box with a ground fault
circuit interrupter. Safety precautions such as keep-
ing all connections o the ground and dry will not
eliminate the danger.
WARNING:
Use only a BISSELL 2X portable machine formula in
your cleaner. Use of cleaning formulas which contain
lemon or pine oil may damage this appliance and
void the warranty. Chemical spot cleaners or sol-
vent-based soil removers also should not be used.
These products may react with the plastic materials
used in your cleaner, causing cracking or pitting.
1A
1B
1C
1D
Water
Formula
2
3
4
5
www.BISSELL.ca
1-800-263-2535
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Littlegreen 1400 series

Table of Contents