Remote Control - Dimplex BF8000ST Practical User's Manual

Remote Control

The fireplace is supplied with a radio frequency remote control. This remote control has a
range of approximately 50 feet. (15.25m), it does not have to be pointed at the fireplace and
can pass through most obstacles (including walls). It is supplied with one of hundreds of
independent frequencies to prevent interference with other units. The frequency designation is
indicated on the back of the transmitter.
Figure 2
NOTE: When fireplace is turned on by transmitter the fireplace will start with flames only. The
level can be increased every time the ON button on the transmitter is pressed
A. Remote Control Initialization
Follow steps 1 through 4 to initialize your fireplace for the first
time. This procedure is also required every time there is a loss
of power to the remote control in the fireplace. (i.e. power
failure, breaker tripped, main power switch is turned off)
1. Ensure that power is supplied to the intended electrical
receptacle.
2. Locate manual controls (refer to Figure 1).
3. Plug in fireplace, first indicator light will flash (Figure 1C)
4. Press and hold the manual selection switch (Figure 1D) for
five seconds (" I " position) UNTIL the second red indicator
light flashes.
5. Press ON button located on the remote control transmitter
(Figure 2). This will synchronize the remote control transmitter
and receiver.
B. Remote Control Usage
The remote control operates the fireplace levels sequentially,
flames only to flames and low heat, to flames and high heat
The level is increased every time the ON button on the
transmitter is pressed. The fireplace can be turned off at any
point by pressing the OFF button on the remote control
transmitter.
Level : The flame effect is turned on and the first red
indicator light flashes momentarily.
Level : The flame effect remains on, the heater is activated
to the low heat setting, and the first and second red indicator
lights flash momentarily.
Level : The flame effect remains on, the heater is set to the
high heat setting, and all three red
indicators flash momentarily.
6