Setting Up The Projector For A Wireless Lan Connection (With The Optional Usb Wireless Lan Unit Equipped) [Wirless Lan] - Dukane 6233 User Manual

Setting up the Projector for a Wireless LAN Connection (with the optional USB Wireless
LAN Unit equipped) [WIRLESS LAN]
Important
• Consult with your network administrator about these settings.
• When using a wireless LAN connection, attach the optional USB Wireless LAN to the projector. (→ page 128)
[PROFILE]
[RECONNECT]
NOTE: After selecting [EASY CONNECTION] from [PROFILE], you cannot make settings to [DHCP], [IP ADDRESS], [SUBNET MASK],
[GATEWAY], and [AUTO DNS] except [CHANNEL].
[DISABLE]
[EASY CONNECTION]
[SIMPLE ACCESS
POINT]
[PROFILE 1]
[PROFILE 2]
Retry to connect the projector to a network. Try this if you have changed [PROFILE].
Wireless LAN connection will be turned off
Select [EASY CONNECTION] to execute a wireless LAN
easily using Image Express Utility Lite on the supplied
NEC Projector CD-ROM.
Set the projector for simple access point.
Selecting [SIMPLE ACCESS POINT] will allow the projec-
tor to create an infrastructure network. The IP address of
the projector will be set automatically.
Select "Obtain an IP Address Automatically" to set the IP
address of a connected computer.
It takes a few seconds for a change of your computer's IP
address to come into effect in Windows 7/Windows Vista
while it takes one or two minutes in Window XP.
When you connect with your computer to save your profile
and select "Automatically connect when within range" from
the Properties tab of Wireless Network in Windows for your
selected profile, your wireless LAN will be accessed under
the following conditions:
• at the time of turning on the computer or the projec-
tor
• when the notebook type is within the range of the
projector's wireless LAN can be achieved.
Data transmission between wireless LAN and wired LAN
is not possible.
When the [SIMPLE ACCESS POINT] mode is used to
send images, it is recommended to connect to only one
computer.
Up to two settings for the USB wireless LAN unit can be
stored in memory of the projector. (→ page 50)
To recall the settings from memory, select [PROFILE 1] or
[PROFILE 2] from [PROFILE].
109
5. Using On-Screen Menu