Turbo Timer Mode - Audiovox Prestige Platinum APS-687C Owner's Manual

Please consult your installing retailer for more information concerning the
options available.
PUSH-BUTTON LED RECEIVER
VALET/OVERRIDE/SAFETY CONTROLSWITCH
The Push-Button LED switch located in the receiver allows you to
temporarily disable the remote starting function of the system. This IS
recommended whenever the vehicle is being serviced.
To place the system in the service mode:
1) With the system disarmed/unlocked, and the ignition switch off, Press
and Hold the Push-Button, found on the windsheild receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED begins to flash two short flashes followed by one long flashes
and continues this pattern until returned to normal mode of operation.
This puts the unit into the R/S Override mode indicating that the remote
start is in the service mode and will not start from RF or any other input
Posse or otherwise.
To exit the service mode:
1) With the system disarmed, Press and Hold the Push-Button, found on
the windsheild receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the R/S unit is fully functional one
again.

TURBO TIMER MODE

This system provides a means to cool down the vehicles turbo charger, if so
equipped, by allowing the vehicle to continue to run for a prescribed period
of time every time the vehicle's engine is turned off. This feature requires
the system to be set up for turbo timer during installation. Consult with
your installation center to be certain this feature was activated and how
long the vehicle will continue to run, 3, 5, or 10 minutes after the ignition
switch is turned off.
Page 6
128-8782b
6 of 12