Manual Firmware Upgrade - ActionTec SBWD50A User Manual

Manual Firmware Upgrade

Follow the procedure below to manually upgrade your receiver:
1. Download and save the new ScreenBeam Mini firmware to your local disk. Check new
firmware from Actiontec's website (www. actiontec.com).
2. Extract the zip file. You will find one "autorun" folder and one "install.img" file in the
extracted file folder.
3. Insert a USB flash drive to your laptop/PC.
4. Copy the "autorun" folder and the "install.img" file to the root directory of the USB flash
drive. Note: Do not use a portable hard drive. You should use a formatted FAT/FAT32
USB flash drive only.
5. Power on your Receiver. Make sure the "Ready To Connect" screen appears on your
TV.
Note: You must disconnect your device (laptop, ultrabook, smartphone or tablet) from
the receiver before upgrading your receiver.
6. Safely remove your USB flash drive from your PC, and plug it into the female connector
of the USB cable.
7. The Receiver starts to upgrade its firmware automatically. Firmware upgrade status
messages appear on your TV.
Warning! Do not power off the Receiver or remove the USB flash drive while the
upgrade is in progress. Otherwise, firmware upgrade fails.
8. The Receiver reboots to complete the upgrade, and the "Ready To Connect" screen
appears again.
9. Upgrade completes. You may now remove the USB flash drive from the Receiver.
33