* Four height rod sections
* Two cutting bits
* Open end wrench
* Two flat washers
FOREWORD
Model 513 Lock Mortiser permits builders and contractors to quickly cut
true, accurate mortises for door box locks.
Model 517 Lock Face Templet allows quick and economical routing for lock
faces on doors after the mortise cut for the lock itself has been completed.
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
STANDARD EQUIPMENT
With the mortiser, the four sections of the height rod (A), and two bits (B) are
furnished. See Fig. 1.
B
ASSEMBLY OF BASE UNIT
The unit is shipped with the crank handle disassembled.
Remove bolt and washer (B and C) Fig. 2. Place crank handle (D) onto crank
shaft (A) with wooden knob facing outward and "D"-shaped hole in handle
aligned with flat on shaft. Place bolt (C) through washer (B) and thread into
shaft (A). Tighten securely.
CARTON CONTENTS
FUNCTIONAL DESCRIPTION
ASSEMBLY
* Two cap screws
* Allen Wrench
* Motor unit
* Mortiser frame
- Allen wrench (supplied)
15 to 30 minutes
Fig. 1
8
A