Table of Contents
Advertisement
Available languages
Available languages
CHANGING BAND SAW FROM
HORIZONTAL TO VERTICAL POSITION
Your saw can be changed to the vertical position for
notching, slitting or contour work as follows:
Disconnect machine from power source.
1. Move the cutting arm to the vertical position and
lock in place with the arm positioning lever (C)
Fig. 32. Stop screw (A) Fig. 32 should bear against
base casting when arm is in the vertical position. If
adjustment is needed loosen lock nut (B) and adjust
screw (A).
2. Remove two screws (C) and bearing cover plate (D)
Fig. 33.
3. Assemble the vertical table (E) to the guide bracket
using the two screws (C) that were removed in
STEP 2, as shown in Fig. 34.
4. Assemble one end of the table support bracket
(G) Fig. 35 to the table using a 1/4-20x1/2" flat
head screw and 1/4-20 nut (H) and the other end
underneath the guide bracket lock knob (J), as
shown in Fig. 35.
E
G
17 - English
B
A
Fig. 32
D
C
C
Fig. 33
C
Fig. 34
H
J
Fig. 35
C
Advertisement
Table of Contents
