Table of Contents
Advertisement
Available languages
Available languages
ADJUSTING BLADE GUIDE BEARINGS
Disconnect machine from power source.
1. The blade guide bearings (A) and (B) Fig. 20 should
be adjusted so they just touch the sides of the
blade (C) after the blade is tracking properly and the
blade support bearing has been adjusted. To adjust,
proceed as follows:
2. Remove the cover plate that is attached to the face
of the right guide bracket (D) Fig. 20.
3. The inside guide bearing (A) Fig. 20, is mounted to
a fixed shaft and cannot be adjusted. The outside
guide bearing (B) is mounted on an eccentric shaft
and should be adjusted so that the sides of the
blade (C) just contact the guide bearings (A) and
(B). To adjust, loosen nut (E) and turn adjusting nut
(F) until proper adjustment is made. Then tighten
nut (E).
4. Adjust the other blade guide bearings in the same
manner.
ADJUSTING BLADE 90 DEGREES TO THE
TABLE SURFACE
In order for accurate work to be accomplished on
your saw the blade must be at 90 degrees to the table
surface. To check and adjust, proceed as follows:
Disconnect machine from power source.
1. Lower the saw arm to the horizontal position. Place
a square (A) Fig. 21, on the table with one end of
the square against the blade, as shown.
2. If the blade is not at 90 degrees to the table, loosen
the two screws (B) Fig. 21, that attach the blade
guide brackets to the guide arms and rotate both
guide brackets (C) until the blade is at 90 degrees
to the table. Then tighten the two screws (B). NOTE:
CARE SHOULD BE TAKEN NOT TO DISTURB
THE BLADE GUIDE SUPPORT BEARINGS WHEN
MAKING THIS ADJUSTMENT.
A
C
B
13 - English
E
D
F
B
Fig. 20
A
B
C
C
Fig. 21
Advertisement
Table of Contents
