DeWalt D28700 Instruction Manual page 8

FIG. 6
E
Q
R
TO CHANGE SPACING BETWEEN THE FENCE AND VISE
Using the wrench provided, loosen and remove the two fence bolts
(Q). Adjust the fence (E) to desired locations. Insert both fence bolts
in provided locations. Securely tighten both fence bolts before use.
Removal and Installation of Wheels
(Fig. 7, 8)
WARNING: Turn off and unplug the tool before making
any adjustments or removing or installing attachments or
accessories. Be sure the trigger switch is in the OFF position.
Do not make any adjustment while the wheel is in motion.
Do not make any adjustment while chop saw is plugged into
power supply.
FIG. 7
J
on when replacing with a new abrasive wheel. It is possible that
the wheel may contact ANY ITEMS OR STRUCTURE THAT
EXTENDS ABOVE work surface (under the base) when the arm
is fully lowered.
Mounting
surface to prevent unexpected movement when operating.
L
7 7
1. Push in wheel lock lever (L) and rotate wheel (J) by hand
until wheel lock lever engages slot in inside flange (S) to lock
wheel. Loosen the bolt (T) counterclockwise in the center of the
abrasive wheel with the 8 mm hex wrench (G). Bolt has right-
hand thread.
FIG. 8
S
2. Remove the bolt (T), washer (U), outside flange (V) and old
wheel (J).
3. Make sure flange surfaces are clean and flat. Install the new
abrasive wheel by reversing the above steps.
4. Do not overtighten bolt.
WARNING: Check the work surface that the chop saw rests
CAUTION: Tool must be supported on stable, level, non-skid
J
V
T
U