Service Information - Black & Decker lCs120 Instruction Manual

3. (Figure X) Keep the correct top
plate (22) filing angle line of 30°
on your file guide parallel with
your chain (file at 60° from chain
viewed from above).
4. (Figure Y) Sharpen cutters (23)
on one side of the chain first.
File from the inside of each
cutter to the outside. Then turn
your saw around and repeat the
processes (2,3,4) for cutters on
the other side of the chain. use a flat file to file the tops of the
rakers (portion of chain link in front of the cutter) so that they are
about .025 inch (.635 mm) below the tips of the cutters.
5. (Figure Z) Keep all cutter
lengths equal.
6. If damage is present on the
chrome surface of the top plates
or side plates, file back until
such damage is removed.
Caution: After filing, the cutter will be sharp, use extra caution
during this process.
note: Each time the chain is sharpened, it loses some of the
low kickback qualities and extra caution should be used. It is
recommended that a chain be sharpened no more than four times.
22
X
60°
Y
.025 in. .025"
.635mm
23
Z
the rBrC™ seal
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the LI-ION battery (or battery pack)
indicates that the costs to recycle the battery (or battery
pack) at the end of its useful life have already been paid
by Black & decker.
RBRC™ in cooperation with Black & decker and other battery
users, has established programs in the united States to facilitate the
collection of spent LI-ION batteries. Help protect our environment and
conserve natural resources by returning the spent LI-ION battery to
an authorized Black & decker service center or to your local retailer
for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery.
registered trademark of the Rechargeable Battery Recycling Corporation.
Accessories are available from your local retailer or nearest
Black & Decker service center.
Replacement chain accessory number RC800
(service part # 623382-00)
Replacement bar service part # 623381-00
warninG: The use of accessories not recommended in this
manual may be hazardous.

serViCe information

All Black & Decker Service Centers are staffed with trained
personnel to provide customers with efficient and reliable power
tool service. Whether you need technical advice, repair, or genuine
factory replacement parts, contact the Black & Decker location
nearest you. To find your local service location, refer to the yellow
page directory under "Tools—Electric" or call: 1-800-544-6986 or
visit www.blackanddecker.com
16 16
RBRC™ is a
aCCessories