Appendix G - Towertray Selftest - HP IU 690 Installation And User Manual

Hewlett packard corporation printer installation and user's guide
Table of Contents

Advertisement

APPENDIX G - TowerTray Selftest

TowerTray Selftest Feature
The TowerTray selftest feature allows to test the TowerTray unit independently from any printer and computer. With
this test you can check for correct paper feeding (horizontal position, skew, jam behavior).
Note:
To perform a TowerTray selftest, remove the printer's paper cassette.
Follow the following steps:
Power-off TowerTray.
Open all TowerTray Trays (approx. 10 cm).
Power-on TowerTray.
Wait until you hear a short beep followed by the clicking of the solenoid activation in every module, and
finally the spinning of the motor (approx. 2 sec).
Close the top-most TowerTray tray. After a second a sheet will be fed from this drawer. You now can mark
the position of the left border of the sheet on the TowerTray top cover (reference for horizontal paper
position).
Pull out the sheet from its waiting position. TowerTray will automatically feed a next sheet. You now can
compare the position of the left border of the next sheet. If it moves up straight in the same position, this is
ok. (In case the left position would be different, or moving from left to right (or vice-versa), this might indicate
a problem in either the tray, the unit (module) or the paper loading.)
To test the next lower tray, close that tray before removing the sheet from its waiting position. Now
TowerTray will feed the sheet from that next lower tray. (TowerTray will always feed the next sheet from its
lowest closed tray.)
To revert to normal operation, power-off and on TowerTray again with all trays closed. TowerTray will
respond with a short 'Reset' beep that it is ready again.
In case error conditions are showing up which are depending on a specific TowerTray tray, you can swap trays to
find out whether a problem exists with the tray itself or whether a specific module is the cause. Please note, that the
top tray (part nr. 206012) MUST always be the topmost tray of TowerTray.
Manual 0545
30
TM
TowerTray
for the HP LaserJet 4200 / 4300 / 4250 / 4350

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents