Table of Contents
Advertisement
Getting Started
Troubleshooting
Symptom
CAUTION
2-14
Suggested Action
3 Clear the X's from all the options except Inspect boot sector, then select Continue (perform
selected tasks) and press Enter.
®
4 Insert Windows
NT Setup Disk 3 when directed then insert the MPEGscope Plus Windows
Disk when prompted.
5 The boot sector repair will take a few seconds. When the message on the screen indicates the repair is
complete, remove all diskettes from the drive and restart the system.
6 After the system restarts, run the Check Disk (chkdsk) utility to determine if any problems remain with
your system disk, as follows:
a) Launch the Disk Administrator from the Start/Programs/Administrative Tools (Common)
menu.
b) From the Disk Administrator, click anywhere in the Disk 0 field to select C: drive.
c) From the Tools menu, select Properties, then select the Tools tab.
d) From the Error–checking box, select the Check Now button.
e) From the Check Disk C:\ dialog, select both Check Disk options—Automatically fix file
system errors and Scan for and attempt recovery of bad sectors.
f) Select Start.
g) An information window is displayed which indicates that the Check Disk process cannot be
performed immediately because the utility cannot obtain exclusive access to the drive.
Click Yes to proceed.
Click OK to close the Properties window.
Close the Disk Administrator window.
h) Shut down and restart MPEGscope. Check Disk will execute during the system startup.
Do not remove the cover or handle any MPEGscope hardware unless advised
to do so by your HP customer support representative. Please disregard any
instructions in your PC user's guide directing you to check or install components
inside your PC. Interfering with MPEGscope hardware may invalidate your
warranty.
®
NT Repair
Advertisement
Table of Contents
