Table of Contents
Advertisement
2. Attach a Wheel (66) to the base of the Uprights (69) with
a Wheel Bolt (64) and a Nut (13) as shown. Do not
overtighten the Wheel Bolt; the Wheel should turn
freely.
With the help of a second person, carefully tip the tread-
mill onto its other side. See assembly step 1 and attach
the other Extension Leg (63) and Base Pads (57). Next,
attach the other Wheel (66) as described above.
With the help of a second person, carefully tip the tread-
mill so the base of the Uprights (69) is flat on the floor.
3. If there is a board (not shown) between the Uprights
(69), remove the two bolts attaching the board. Discard
the board and the bolts.
Remove the tie from the Wire Harness (42). Hold one of
the Handrails (71) near the right Upright (69), and insert
the Wire Harness into the opening in the bottom of the
Handrail and out of the indicated hole in the top.
Set the Handrail (71) on the right Upright (69), and
tighten two Handrail Bolts (93) with two Handrail Star
Washers (95) into the Handrail and the right Upright.
Make sure that the Wire Harness (42) is not pinched.
Attach the other Handrail (71) to the left Upright (69) as
described above. Note: There is not a wire harness on
the left side.
4. Have another person hold the Console Base (47) near
the right Handrail (71). If there is a green ground wire
coming from the Console Base, attach the end of the
ground wire to the indicated small hole in the right
Handrail with the Silver Ground Screw (75).
Connect the Wire Harness (42) to the wire harness on
the Console Base (47). Make sure to connect the con-
nectors properly (see the inset drawing). The con-
nectors should slide together easily and snap into
place. If the connectors do not slide together easily and
snap into place, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
2
3
93
95
4
42
7
64
66
69
13
71
42
69
93
95
71
69
47
75
Ground
Wire
71
42
Hide quick links:
Advertisement
Table of Contents
