Checking Tire Pressures; Seat Adjustment; Mowing Height Adjustment - Snapper S150XTKAV2048 Operator's Manual

Operation
Check Tire Pressures
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note
that these pressures may differ slightly from the "Max
Inflation" stamped on the side-wall of the tires. The
pressures shown provide proper traction, improve cut
quality, and extend tire life.
Tire Pressure
psi bar
Rear 15 1,03 All
Front 25 1,72 Models with pneumatic tires
Front N/A

Seat Adjustment

See Figure 2. The seat can be adjusted forward and
backward. Move the lever towards the left, position
the seat as desired, and release the lever to lock the
seat into position.

Mowing Height Adjustment

The cutting height adjustment pin (A, Figure 3) control
the mower cutting height. The cutting height is
adjustable between 1-3/4" (4,4 cm) and 5" (12,7 cm)
in 1/4" (0,64 cm) increments.
1. Depress the deck lift foot pedal (B) until it locks
into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in the
desired cutting height.
3. Depress the deck lift foot pedal then push the lock
lever (C) toward the right to release the lock.
4. Release the deck lift foot pedal until it comes to
rest against the cutting height adjustment pin.
16
Fits Models:
Models with flat free tires
Figure 1. Checking Tire Pressure
A
Figure 2. Seat Adjustment
A. Seat Adjustment Lever
B
Figure 3. Mowing Height Adjustment
A. Cutting Height Adjustment Pin
B. Deck Lift Foot Pedal
C. Deck Lift Lock lever
A
C
www.SnapperPro.com