Advertisement
Symptom
Signal not properly connected.
Disc warped or dirty.
No sound
Player in mute status.
Signal not properly connected.
No picture
TV not set for proper system.
TV system not right.
No color
TV set color not properly adjusted.
No disc in the player.
No disc reading
Disc not properly loaded.
Condensation on the laser head.
Remote control not pointing to the sensor
window.
Remote control
Remote control's operating distance more
failure
than 8 meters away from your TV set.
Batteries low.
Mal-fabricated disc used.
Temporary
Wrong buttons pressed.
function failure
Static leakage into the player from outside.
Picture rolling
TV set system not properly adjusted.
Cause
26
Correction
Connect signal securely.
Clean your disc.
Press MUTE button again.
Connect signal securely.
Reset the AV/TV status of your TV set.
Press P/N button on the remote control to set the system.
Readjust color of your TV set.
Load a disc.
Reload a disc, with the label side facing up.
Turn on the player, unload the disc and leave it on for about one hour.
Use the remote control properly.
Replace both batteries.
Wait 5~10 seconds and the player will automatically return to normal.
Operate once more.
Turn off the player for 1 to 2 minutes, then turn it on again.
Readjust system of your TV set.
Advertisement
