Table of Contents
Advertisement
5. Inspect the Venting System
The appliance and venting system should be inspected before use, and at least annually, by a qualified field service person, to
ensure that the flow of combustion and ventilation air is not obstructed.
6. Cleaning the Glass
In the event of glass breakage, carefully remove the glass frame. This will allow the removal of all glass fragments and sheet metal
edge protection strips. Vacuum all remaining glass pieces with a shop vac. DO NOT VACUUM IF THE PIECES ARE HOT!
Replace glass with only a Heatilator Glass Panel Assembly ordered through your local distributor. Never use substitute material.
Only fully tempered soda lime safety glass or ceramic glass may be used on this appliance.
7. Log Removal/Replacement
If removal of the logs becomes necessary, remove two screws from the front of the grate. Lift and pull the log set towards the front
of the appliance, up and off the burner. See Figure 23.
To replace the logs, push and lower the log set onto the burner pan, making sure the back of the right most grate bar slides through
the grate mounting bracket attached to the hearth pan. Replace the screws in the grate.
18
(See Figure 22.)
Figure 22 - Glass Cleaning
Figure 23 - Log Removal
NOVUS PLUS INSTALLATION INSTRUCTIONS
4031-478 Rev i
SAFETY NOTE: Handle
glass with care to avoid
striking, scratching or
slamming shut. NEVER
clean the glass when it is
hot. Keep children and pets
a safe distance away.
WARNING!
NEVER operate this appli-
ance without the glass
properly secured in place
or if the glass is broken or
chipped.
11/04
Advertisement
Table of Contents
