Table of Contents
Advertisement
Cleaner Height Setting
WARNING: Avoid injury. Keep loose clothing, hair, fingers, and all other parts of
body away from any moving part (such as the revolving brush). Turn
off the switch and unplug the cleaner before changing the cleaner
height setting.
Adjust the vacuum cleaner height
setting to match the carpet pile height.
Refer to the following char t of
recommended settings for carpet types.
The front of the cleaner has either a
knob or slide adjustment which raises
or lowers the cleaner base to match the
type of carpet. With the cleaner cord
unplugged, set the adjustment
according to the table as a starting
point. While the cleaner is off and
disconnected from the outlet, place
the handle in the operating position, tilt
the cleaner back to remove the weight
from the wheels, and adjust the setting. Then plug the cleaner into the electrical outlet,
turn on the switch, lower the handle, and pass the cleaner over the carpet. If the
cleaner is still difficult to push, follow the procedure and test the cleaner at the next
higher setting. Continue testing the setting until the cleaner is comfortable to move.
Moving the knob or slide to the next higher setting raises the brush roll slightly, making
the cleaner easier to push. However, the brush roll must make contact with the carpet
for effective cleaning.
Recommended
Setting
Position 1
Position 2
Position 3
Position 4
If the cleaner has additional height settings, they are for thicker
carpets or where easier pushing is desired.
Example of Carpet
Low pile as kitchen, indoor,
outdoor
Sculptured
Plush or thick sculptured
Thick plush
9
Advertisement
Table of Contents
