Table of Contents
Advertisement
Step 2
Attach Upper Cord Hook
Pull the spring on the electrical cord upward toward the
top of the handle. Make sure slots in handle are positioned
properly, see below.
1. Place inner tab
into slot
Insert the lower half of the spring into the upper cord
hook (B), as shown. Snap the hook into the upper handle,
directions below.
Step 3
Attach Lower Cord Hook
Make sure cord hook is pointing
downwards. Press the power cord into the
groove on the cord hook pulling any slack
toward the base of the cleaner. On the cord
hook, find the curved tab and place in slot
on lower handle section, keep cord taut
while pressing the cord hook to the left until
it snaps into slot on opposite side of handle.
The hook should point downward on the
same side that the cord exits the hood.
Step 4
Attach Outer Bag
Important: To provide a good gasket seal,
the bag coupling must seat firmly
against the motor base.
Hold outer bag with zipper away from the
handle. Line up screw holes. Start the bag
screws by hand, then tighten with a
screwdriver.
Loop the bag spring onto the bag support
hook located at the back of the upper cord
hook.
2. Press hook
around handle
3. SNAP opposite inner
tab into place
B
BAG
SUPPORT
HOOK
3
4
7
Advertisement
Table of Contents
