Stopping The Engine - Exmark Laser Z XS Operator's Manual

2. Pull up and back on the parking brake lever to
engage the parking brake.
3. Push in on the PTO switch to the "STOP"
position.
Note: It is not necessary for the operator to be
in the seat to start the engine.
4. On a warm engine, place the throttle in the
"SLOW" position.
5. On a cold engine, (below 14°F (-10°C)), place the
throttle in the "MIDWAY" position.
Note: Do Not use fuel left over from summer.
6. Turn ignition switch to the "ON" position.
Depress the glow plug switch and the glow plug
light will turn on. Hold switch as required by
chart below. Turn the ignition switch to the
"START" position. Release the ignition switch as
soon as the engine starts.
Glow Plug Chart
Ambient Temperature
Above 50°F (10°C)
50°F (10°C) to 23°F (-5°C) Approximately 5 seconds
Below 23°F (-5°C)
Limit of continuous use
The glow plug light, located near the glow
plug switch, will illuminate when the switch is
depressed. The glow plug light indicates the glow
plugs are preheating the combustion chamber.
Important: Do Not crank the engine
continuously for more then ten seconds at a
time. If the engine does not start, allow a 30
second cool-down period between starting
attempts. Failure to follow these guidelines
can burn out the starter motor and/or fuel
solenoid.
7. Move the throttle to the "SLOW" (if in
"MIDWAY") and let the engine warm up a few
minutes before moving the throttle to the "FAST"
position.
Hold Glow Plugs On
NO NEED
Approximately 10 seconds
20 seconds
Engaging the PTO
DANGER
The rotating blades under the mower deck
are dangerous. Blade contact can cause
serious injury or kill you.
Do Not put hands or feet under the mower
or mower deck when the blades are engaged.
DANGER
An uncovered discharge opening will allow
objects to be thrown in an operator's or
bystander's direction. Also, contact with the
blade could occur. Thrown objects or blade
contact can cause serious injury or death.
Never operate the mower with the discharge
deflector raised, removed, or altered unless
there is a grass collection system or mulch
kit in place and working properly.
The PTO push-pull switch engages the cutting blades.
Be sure that all persons are clear of the mower deck
and discharge area before engaging PTO.
Important: Operator must be in seat before the
PTO can be engaged.
1. Set the throttle to the "MIDWAY" position.
2. Pull the PTO switch outward to the "ROTATE"
position.
3. Place the throttle in the "FAST" position to begin
mowing.
Disengaging the PTO
1. Set the throttle to the "MIDWAY" position.
2. Push the PTO switch in to the "STOP" position
to disengage the blades.

Stopping the Engine

1. Bring the unit to a full stop.
2. Disengage the PTO.
3. Move the motion control levers out to the neutral
lock position.
4. Engage the parking brake.
5. Place the throttle midway between the "SLOW"
and "FAST" positions.
23
Operation