Adjustments - Exmark Turf Tracer Operator's Manual

b) Square head setscrews on Hydro pump control arms.
c) Shoulder bolts in ends of speed control crank.
e) OPC lever setscrews.
f) Electric clutch retaining bolt.
g) Pump drive idler pivot bolt.
Adhesives such as "Loctite RC/609 or RC/680" or "Fel-Pro Pro-Lock Retaining
I or Retaining II" are used on the following:
a) OPC lever hubs and cross-shaft
NOTE: Care must be used not to bond the bearing, next to each OPC
hub, to the cross shaft which could cause binding of the OPC levers and
erratic operation.
5.1.20 An anti-seize compound is used between the cutter housing spindles and the
sheaves.
5.1.21 Dielectric grease is used on all blade type electrical connections to prevent
corrosion and loss of contact.

5.2 ADJUSTMENTS

IMPORTANT: Disengage blade clutch, shut off engine and remove key before
servicing, cleaning or making adjustments.
5.2.1 Cutting height and anti-scalp roller adjustment.
POTENTIAL HAZARD
♦ When cutter deck is not installed or the two front
support rod hairpins are removed, the tractor or tractor
with mounted cutter support frame may cause the
front of the unit to rise suddenly.
WHAT CAN HAPPEN
♦ If the unit rises suddenly, injury may occur.
HOW TO AVOID THE HAZARD
♦ Securely hold down the front end of the unit when the
cutter deck is not installed or front support rod hairpins
are removed.
a) Install hairpin clips in the holes shown on sketch below for the desired
cutting height (See Figure 7).
CAUTION
FIG 7
ANTI-SCALP ROLLER BOLT INSTALLATION
ANTI-SCALP ROLLER ADJUSTMENT
CUTTING HEIGHT ADJUSTMENT
- 26 -