JVC RX-D205S Instructions Manual page 84

❏ Changing the transmittable signals for operating
a VCR
1
Press and hold STANDBY/ON
2
Press VCR.
3 Enter the manufacturer's code using buttons
1 – 9, and 0.
See "Manufacturers' codes for VCR" on the right.
4 Release STANDBY/ON
Now, you can perform the following operation on the VCR.
STANDBY/ON Turn on or off the VCR.
VCR:
After pressing VCR, you can perform the following operations
on the VCR.
CHANNEL +/–: Change the channel numbers on the
VCR.
3:
Start playback.
7:
Stop playback.
8:
Pause playback.
FF: Fast-wind a tape.
REW: Rewind a tape.
REC PAUSE: Enter recording pause. To start
recording, press this button then 3.
See the instructions supplied with the VCR for details.
5 Try to operate your VCR by pressing
STANDBY/ON VCR.
When your VCR turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of VCR, try each
one until the correct one is entered.
VCR.
VCR.
Manufacturers' codes for VCR
Manufacturer Codes
JVC 01, 02, 03
Emerson 10, 22
Gold Star 11
Hitachi 04
Mitsubishi 12
NEC 21
Panasonic 07, 13
Philips 09
RCA 05, 06
Samsung 20
Sanyo 17, 18, 19
Sony 14, 15, 16
Zenith 08
Initial setting: 01
Manufacturers' codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
37