Tile Cutting Accessories - Husqvarna TS 250 XL Operator's Manual

15

TILE CUTTING ACCESSORIES

ANGLE GUIDE PROTRACTOR
Parts List:
Diag. Part No.
1 542 05 01-04*
2 542 05 01-07*
3 542 05 01-05*
4 542 05 01-06*
5 542 05 01-03*
6 542 18 97-37*
7 542 05 10-20*
8 542 18 97-37*
9 N/A
RIP GUIDE: P/N 542 05 10-00* - The Rip Guide is a
standard accessory supplied with every tile saw. It is
used to provide a repeatable position for rip cuts until
relocated. The Rip Guide clamps to the machined
backstop of the conveyor cart.
ADJUSTABLE PROTRACTOR: P/N 542 05 10-10* - The
Protractor can be used to rip cut known angles. The
protractor clamps to the backstop.
ANGLE GUIDE : P/N 542 05 10-20* - This is a non-
adjustable miter used to quickly position the tile at
45 degrees; either on the left or right side. It is often
used for repeated diagonal rip cuts. The Angle Guide
clamps to the backstop.
The instructions for use and spare parts found in this document are for information only and are not binding. As part
of our product quality improvement policy, we reserve the right to make any and all technical modifications without
Qty. Description
1 Frame, Miter
1 Bar, Locking
1 Clip, Stop
1 Spring
1 Knob
2 Knob, 1/4"-20 x 1"
°
1 Miter Assy, 45
1 Knob, 1/4"-20 x 1"
1 Sector Plate
The manufacturer accepts no
responsibility caused by unsuitable
use or modifications.
MITY MITRE GUIDE
Diag. Part No.
10 N/A
11 542 02 00-11*
12 542 02 02-44*
13 542 18 97-37*
14 542 05 10-10*
15 542 02 05-98*
16 542 05 10-30*
17 542 05 10-41*
18 542 05 01-02*
BULLNOSE MITRE GUIDE: P/N 542 05 10-30* -This is a
fixed guide that positions the tile for a 45 degree miter
cut. The Mitering Guide clamps to the backstop.
MITY MITRE GUIDE: P/N 542 05 01-02* - This is a 45
degree fixture that has an adjustable clamp to hold
the tile while miter cutting. The Mitering Guide clamps
to the backstop.
FOLDING STAND: P/N 542 05 10-41* - This stable, one
piece stand brings a Husqvarna® tile saw to standing
level for ease of work. The stand conveniently folds
flat for storage and transporting.
prior notice.
BULLNOSE FOLDING STAND
Qty. Description
1 Arm, Protractor
1 Carriage Bolt, 1/4"-20 x 5/8"
1 Wing Nut, 1/4"-20 x 1"
1 Knob, 1/4"-20 x 1"
1 Protractor Assy
1 Screw, Thumb, 1/4"-20 x 1"
1 Holder Assy, Bullnose
1 Stand, Tile Saw
1 Support Assy, Miter Frame
17