Cutting Equipment - Husqvarna 324R X-SERIES Operator's Manual

2 Keep the teeth of the blade correctly sharpened! Follow
our instructions and use the recommended file gauge. An
incorrectly sharpened or damaged blade increases the
risk of accidents.
3 Maintain the correct blade setting! Follow our instructions
and use the recommended blade setting tool. An
incorrectly set blade increases the risk of jamming and
kickback.
4 Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be replaced.
Quick release
Check that the harness straps are correctly positioned. Once
the harness and machine have been adjusted, check that the
harness quick release works correctly.
Locking nut
• When fitting, tighten the nut in the opposite direction to the
direction of rotation of the cutting attachment. To remove
it, undo the nut in the same direction as the cutting
attachment rotates. (CAUTION! The nut has a left-hand
thread.)
8 –
English
SAFETY INSTRUCTIONS
• Tighten the nut using the socket spanner. 35-50 Nm (3.5-
5 kpm).
CAUTION! The nylon lining inside the locking nut must not
be so worn that you can turn it by hand. The lining should
offer a resistance of at least 1.5 Nm. The nut should be
replaced after it has been put on approx. 10 times.
WARNING! Never use a machine with faulty
!
safety equipment. The machine's safety
equipment must be checked and maintained
as described in this section. If your machine
fails any of these checks contact your
service agent to get it repaired.

Cutting equipment

IMPORTANT!
This section describes how to choose and maintain your
cutting equipment in order to:
Reduce the risk of blade thrust.
Obtain maximum cutting performance.
Extend the life of cutting equipment.
Only use cutting attachments with the guards we
recommend! See the chapter on Technical data.
Refer to the instructions for the cutting attachment to check
the correct way to load the cord and the correct cord
diameter.
Keep the teeth of the blade correctly sharpened! Follow our
recommendations. Also refer to the instructions on the
blade packaging.
Maintain the correct blade setting! Follow our instructions
and use the recommended file gauge.
WARNING! Using an incorrect cutting
!
attachment or an incorrectly sharpened
blade increases the risk of kickback.
Sharpening the saw blade
• See the cutting attachment packaging for correct
sharpening instructions.
• A correctly sharpened blade is essential for working
efficiently and to avoid unnecessary wear to the blade and
clearing saw.